PVC Ceiling Panel & Wall Panel Production Line
A complete PVC ceiling and wall panel extrusion line — extruder, sheet die, vacuum calibration table, haul-off, cutting machine and stacking — built and tested in our Zhangjiagang workshop before shipment.
Line sections in detail
The three units below are the downstream sections that decide panel flatness, surface finish and dimensional accuracy. Every unit is assembled, wired and run in our workshop before the line is packed.
Process flow
Typical configuration
Configurations are confirmed per project — the values below show the common range for PVC ceiling and wall panel lines.
| Material | PVC compound with calcium carbonate, additives |
|---|---|
| Extruder | Conical twin screw (e.g. SJZ 51/105 or 65/132), model confirmed by panel width and output |
| Panel width | Typical 200–600 mm (including wide wall panels) |
| Panel thickness | Typical 5–10 mm |
| Downstream | Vacuum calibration table, haul-off, automatic cutting machine, stacker |
| Options | Online lamination / hot-stamping, surface embossing, extra calibration length, automatic packing |
Why customers choose this line
- Dimensional stability — long vacuum calibration section keeps width and thickness consistent along the coil
- Surface quality — sizing sleeves and roller finish matched to your panel design
- Low changeover cost — quick-change die and calibration sleeves for different panel profiles
- Factory tested — wired to drawing, labelled and run at our workshop before shipment
- Documented — operation manual, maintenance manual and spare-part list supplied with the line
Frequently asked questions
Can the line run both ceiling panels and wall panels?
Yes. Ceiling panels (narrow, thin) and wall panels (wider, thicker) use the same line with a different die and calibration set — many customers run both on one line.
What output can we expect?
Output depends on panel width, thickness and formulation. Send us your panel drawing and target capacity and we will confirm the extruder size and line speed.
Do you supply installation and training?
Yes — overseas installation, commissioning and operator training are available, together with a documented spare-part list.
Tell us the panel width, thickness, material formula and target output — we will come back with a line proposal, layout drawing and quotation.
Request a project quotation